TRU GLO Range Rover single pin sight?

[PAdroptine]

I'm looking into buying one but am a little confused on how i would have to sight it in is it any different from a multiple pin sight?

[youngbuck83]

Very simple...dunno what others do but I started out at 10 yards, got it hitting dead center. This setting is usually good for 20yds as well. Then Just keep moving the sight and mark it when you hit a good bullseye group for the appropriate yardage....hope i didn't confuse ya.

[YorkArcher]

youngbuck is absolutely right.

Get it hitting at 10 and 20 and just keep moving back...

As you work back adjust the site and mark the tape when your shootin bulls..

[PAdroptine]

thanks ya it seems pretty easy, but what do you use to mark the different yardages on the thing on the side?

[YorkArcher]

The image I saw of it on cabelas shows the strip of paper / tape that you mark with a pen....

You just line the needle on the right up with the marks you make on the paper and it moves your pin up and down....

[PAdroptine]

ooo ok thanks

[PAdroptine]

Also what yard marks do you set the sight up for like 20 30 40 50 60, or like 20 25 30 35 40 45 50 55 60?

[youngbuck83]

I would use a pencil...just for the simple fact if you change bows or poundage you can erase and start over. I have 20.30.40.50.60 marked on mine.

[YorkArcher]

Originally Posted by youngbuck83

I would use a pencil...just for the simple fact if you change bows or poundage you can erase and start over. I have 20.30.40.50.60 marked on mine.

I do the same

[PAdroptine]

Ok thanks a lot