View Single Post
  #11  
Old 12-03-2008, 09:37 PM
encore encore is offline
Muley
 
Join Date: Jan 2008
Location: wisconsin
Posts: 96
Default

have him try turning the trigger stop screw out a couple of turns so the trigger has more travel, seemed to work for me, mine was set so that the hammer dropped at the same time the trigger hit the stop screw, and i think the hammer was trying to go into the saftey mode and not allowing the firing pin to go forward all the way,i also cleaned the firing pin housing, just one screw to take out,( be very careful not to lose the pin return spring it's pretty small) point the back of the stock up when you push the housing out and there should be no problems. i shot 40 rounds through it with no problems and that was with the hammer extention on it.---tom
Reply With Quote