cutting carbon arrows
 

The only place that I know of that cuts carbons is in saskatoon which is 2.5 hours away and I won't be going there for probably a few months.Is there a way to cut my arrows with out a arrow cutter,would a dremil tool work or should I just leave them till I goto saskatoon again?

timba

Pretty any high speed abrasive cut off wheel would work. A dremel should work fine, just try to keep the end of the cut as square as possible. If you want to make sure, G5 makes a tool called the A.S.D (arrow squaring device) that work great for that purpose. I think it's about $30, definitely cheaper than a trip to Saskatoon!!!:cool:

Thanks I'll give that a try.

timba

I have an Arrow Squaring Device and it is WONDERFUL! Not only can you square your shafts, but you can also use it to square your inserts, which will make your groups MUCH tighter! :)